4.4 Security Menu
Set Supervisor Password
A supervisor password must be set before a lower-level user
password can be set. After selecting Change Supervisor
Password, press Enter. You will be prompted for the new
password, and then again to verify it. Type in 6 or fewer keystrokes.
If you make an error, press Esc to start over.
Set User Password
With a User password, you can enter the Setup Utility and change
or remove the User password, but you cannot enter the Setup
Utility and change or remove the Supervisor password, nor enable
diskette access if it has been disabled.
Booktop M1022 SERIES USER'S MANUAL
4.5 Boot menu
Quiet Boot
[ Enabled ] / [ Disabled ] Booting in Text Mode.
Boot Type Order
To select the boot device, you can use the up or down arrow key,
then press <F7> to move up the device in the list or press <F8>
to move down the device in the list. To exit from this menu, press
<Esc>.
27