Gigabyte GA-M61PME-S2 User Manual page 66

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Under Integrated Peripherals, ensure NV SATA Controller is enabled. To configure a RAID array,
go to the Serial-ATA RAID Config submenu.
On-Chip IDE Channel
NV SATA Controller
IDE Prefetch Mode
USB Memory Type
Serial-ATA RAID Config
Onboard Audio Function
On-Chip MAC Lan
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
On-Chip USB
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
: Move Enter: Select
F5: Previous Values
Set NV SATA RAID function to Enabled to enable RAID control for the first and second SATA
connector. Make sure NV SATA 1 Primary RAID and NV SATA 1 Secondary RAID are enabled.
(Figure 2)
NV SATA RAID function
NV SATA 1 Primary RAID
NV SATA 1 Secondary RAID
: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
GA-M61PME-S2 Motherboard
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Serial-ATA RAID Config
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[Enabled]
[Enabled]
[SHADOW]
[Press Enter]
[Auto]
[Auto]
[Disabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
[V1.1+V2.0]
[Disabled]
[Disabled]
[Enabled]
F10: Save
Figure 1
[Enabled]
[Enabled]
[Enabled]
F10: Save
Figure 2
- 66 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults