Epson EasyMP EMP-735 Setup Manual page 43

Connecting in Access Point Mode
Connection Settings on the Projector
First, set up the connection settings on the projector. Connection settings are found
on the Access point mode advanced settings screen of the Network Screen.
Modify these connection settings using the projector's remote control.
If these settings are already established, this step need not be performed.
Tip :
Apply the following settings under the direction of the network systems administrator.
1
Insert the wireless LAN card into the card slot on the projector.
See "Installation" for details.
2
Press the [Power] button on the remote control to turn the projector on.
3
Repeatedly press the [Comp/EasyMP] button on the remote control until
"EasyMP" is displayed at the top right of the projection screen. EasyMP
will start and display the following screen.
42
p.16