NEC FS-5172 Instruction Manual page 15

Fine Tuning
If you are unable to get a good picture or sound
because of a poor broadcasting signal, it is possible to
fine tune a signal.
CH
Select channel frequency ("FREQ.") function.
VOL VOL
Press and release the remote control CURSOR
RIGHT/LEFT buttons to fine tune a signal.
CH
Enter station name
Select "NAME" function.
CH
MENU
Use the CURSOR RIGHT/LEFT buttons to select the
VOL VOL
character (letter) you want to modify.
To modify this letter press the CURSOR UP/DOWN
CH
buttons until the desired letter is displayed.
Store programme in memory
Select "STORE TO" function
PICTURE/OK
Adjust the programme number you want to store and
confirm by pressing the remote control "PICTURE/OK"
button.
Remarks: This function can be also used if you want to
FRONT P ANEL KEY OPERA
FRONT P ANEL KEY OPERA
You can call up the MENU without the remote control
unit. You can enter the MENU directly by pressing the
MENU button. If you press the MENU button over 1
sec, the MENU will be displayed on the screen. : If you
press the MENU button less than 1 sec, the screen will
be converted to AV mode.
Move the cursor to the SUB MENU you want by using
the CH UP/DOWN buttons and press the MENU
button, then the SUB MENU will be displayed on the
screen. When the SUB MENU is displayed on the
screen you can set it by using the CH UP/DOWN or
the VOL UP/DOWN buttons. Press the MENU button to
return to the previous Menu.
Using the front panel key buttons, some function will not
be available such as : MOVE,
ON/OFF
CH
copy a programme already memorized to
another programme number.
DELETE,
AUTOSETUP, etc.
TV/VIDEO
VOL
MENU STAND-BY
Warning: This television has
been factory pretuned to
channels 2, 7, 9, 10 and 28. If
the auto search function is
activated, these preset channels
will be deleted and new
channels tuned to 1, 2, 3 ETC..
TION
TION
SKIP,
VIDEO AUDIO
13