Table of Contents
Advertisement
Fix cover (C) on guide (A) until it clips into
place.
A
C
Open the appliance door and the furniture
door at 90°. Insert the small square (B) into
8mm
guide (A).
Put together the appliance door and the
furniture door and mark the holes as indi-
cated in the figure.
Remove the squares and drill holes with Ø
A
2 mm at 8 mm from the outer edge of the
door. Place the small square on the guide
B
PR167
again and fix it with the screws supplied.
Should the lining up of the furniture door
be necessary, use the clearance of slots.
At the end of operations, it is necessary to
check if the door of the furniture closes
properly.
PR168
Fix cover (D) on guide (B) until it clips into
place.
B
D
PR167/1
10
Advertisement
Table of Contents
