Tripp Lite SmartOnline SU1500XLCD Owner's Manual page 24

Operation
8 The EXTERNAL BATTERY TYPE selection screen will appear.
EXTERNAL BATTERY TYPE refers to the ability for the UPS to become aware of which external
battery pack is connected to the UPS. Setting the external battery configuration enhances
the accuracy of the MINUTES RUNTIME countdown during power failure conditions. The LCD
interface supports no external batteries with the factory configuration of BP0. Two additonal
LCD configurable external battery pack options are available under the user selection of BP0,
BP1 & BP2. See the table to determine whether BP1 or BP2 applies to your external battery
pack. If your battery pack is not listed or you are using more than one of any supported
external battery pack, you must use Tripp Lite's EXTERNAL BATTERY CONFIGURATION TOOL
software available for download at this link: http://www.tripplite.com/bpconfig
NOTE: Use the BP0 setting if you plan to use the EXTERNAL BATTERY CONFIGURATION TOOL
software. After the software configuration is run, the UPS LCD screen will report "BPC".
The UPS can be reset from BPC to BP0, BP1 or BP2 settings via the LCD screen, but once
the new configuration is set, you'll need to run EXTERNAL BATTERY CONFIGURATION TOOL
software again to re-configure back to the unique BPC setting.
UPS MODEL BP0
SU1000XLCD No BP
No BP
SU1500XLCD
No BP
SU2200XLCD
SU3000XLCD No BP
ACCEPT AND ADVANCE
To ACCEPT the current value
& ADVANCE to the next
configuration screen, press
the ON/SELECT button (less
than 1 second).
9
The VIEW IP ADDRESS selection screen will appear.
The VIEW IP ADDRESS is a display field that enables viewing of the current UPS IP address when
the SNMPWEBCARD option is in use. The UPS is only capable of displaying a IPv4 level IP address
when configured with the SNMPWEBCARD. If VIEW IP ADDRESS is attempted for IPv6 level IP
address or for a UPS configuration without the SNMPWEBCARD, the LCD screen will report NA.
ACCEPT AND ADVANCE
To ADVANCE to back to the
OUTPUT VOLTAGE selection
screen, press the ON/SELECT
button (less than 1 second).
13-03-138 93-3168-EN.indd 24
BP1 BP2
Qty 1 BP24V15RT2U Qty 1 BP24V28-2U
Qty 1 BP48V24-2U Qty 1 BP48V60RT3U
Qty 1 BP48V24-2U Qty 1 BP48V60RT3U
Qty 1 BP72V15-2U Qty 1 BP72V28RT3U
VIEW ALTERNATE SETTINGS
To VIEW ALTERNATE SETTINGS,
press the SETUP BUTTON
repeatedly (under 1 second
each).
AVAILABLE VALUES
BP0 (factory), BP1,
(BPC reflects a software set
configuration)
VIEW ALTERNATE SETTINGS
To VIEW IP address information
in 3 digit segments, press the
SETUP button repeatedly (less
than 1 second).
24
ALL OTHER BATTERY PACK CONFIGURATIONS
Use EXTERNAL BATTERY CONFIGURATION TOOL software
Use EXTERNAL BATTERY CONFIGURATION TOOL software
Use EXTERNAL BATTERY CONFIGURATION TOOL software
Use EXTERNAL BATTERY CONFIGURATION TOOL software
LEAVE UPS SETUP MODE
To leave UPS setup mode,
PRESS and HOLD the SETUP
BUTTON (about 3 seconds).
BP2
LEAVE UPS SETUP MODE
To leave UPS setup mode,
PRESS and HOLD the SETUP
BUTTON (about 3 seconds).
3/28/2013 1:05:44 PM