REMOVING THE OVEN DOOR GASKET
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electri-
cal shock.
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
FIBERGLASS
GASKET
SNAP CLIP
INTO HOLE
OVEN
LINER
3-29
Cooking Products Service Manual
Original
July, 1996
© 1996 Whirlpool Corporation
1. Turn off the gas to the range and disconnect the
power cord from the wall outlet.
2. Open the oven door and pull the clips on the old
fiberglass gasket out of the holes in the front of
the oven, and install the new gasket in its place.
3. Close the oven door and check to make sure
that the gasket seal is tight and even around the
door.
4321891
Page 3-29