Whirlpool RHH 7630 Installation And Operating Instructions

INSTALLATION and OPERATING INSTRUCTIONS
f or
%hpool
VENTLESS RANGE HOOD
RHH 7630
TO INSTALL RANGE HOOD
For an easier installation, remove the filters and the three
assemblies shown in Fig. 3. This reduces theweight about
40%. The blower cover and light frame assembly are held
into place by spring latches. To remove simply grasp and
pull as indicated in Figure 3. To remove the blower
assembly, first unplug the blower powersupply cord from
the junction box. Then pull the blower retaining rod to one
side, freeing it from between the bumps on the blower
housing.
1.
2.
3.
Remove screw holding junction box cover.
Remove proper electrical knockout. See Figure 1
Lift the hood into position. Mark location of four
mounting holes.
4. Remove hood and start all four screws in center of
narrow neck of keyhole slot marked on cabinet
bottom (Fig. 2).
5.
Lift into position on four screws
simultaneously
feeding electrical wire through knockout.
6. Complete electrical wiring in junction box according
to the National Electrical Code and applicable Local
Codes, NOTE: Thus Unit must be permanently
grounded.
7.
8.
9.
Tighten screws to secure hood. Be sure screw head
is in narrow neck of keyhole slot.
Replace junction box cover
Replace blower cover, light frame assembly and
filters.
10. Replace blower.
KEYHOLE SLOT
IN CANOPY
SCREW1
(IN INSTALLATION
PARTS BAG)
L WIRING KNOCKOUTS
FIG. 1
LIGHT 7
SWITCH '
LIGHT FRAI\:E
ASSEMBLY
--FAN CONTROL
SWITCH
'-mBL@,LEH
-BLOUER
'COVER
'EILOhER CRADLE
-BLOWER
RETAINING
ROD
- JUNCTlOh
@OX
FIG. 3