Vax Turbo Force Ultra V-006U Instruction Manual page 8

Vax V-006 D5 BF 7/1/05 12:13 PM
Dirt Container & Filter: Removal & Replacement
2. Remove the dirt container lid by turning it anti-
clockwise (Fig.6/2).
Fig.6/2
3. Hold the dirt container and grasp the top of the
filter. Twist and pull the filter up and out (Fig.6/3).
Fig.6/3
4. Empty the dirt container completely (Fig.6/4).
Fig.6/4
5. Each time the dirt container is emptied, the filter
should be cleaned. Tap the filter against the side
of a rubbish bin until the dust stops falling from
the filter. Return the filter to the dirt container.
Push the filter into place to prevent dirt leakage
(Fig.6/5).
Fig.6/5
8
Page 8
6. Align slots on the lid with the tabs on the dirt
container (Fig.6/6A). Push the lid down and twist
clockwise.
NOTE: There is a guideline on the back of the dust
container lid. Align the line with the arrow on the dirt
container and turn clockwise until secure (Fig.6/6B).
A B
Fig.6/6A
Fig.6/6B
7. Return the dirt container to the vacuum cleaner.
Set the aligning tab on the bottom of the dirt
container into the rectangular slot on the cleaner
(inset). Push to click into place (Fig.6/7).
Fig.6/7
7. Rotating Brushbar:
Removal & Replacement
WARNING: To reduce the risk of injury from moving
parts, unplug the cleaner before changing the belt or
the rotating brushbar.
Tool required: Phillips screwdriver.
To Remove the belt
1. Lay the vacuum cleaner flat and turn it over to
expose the nozzle base. The base should lay flat
and face upwards. To remove the nozzle guard,
use a Phillips screwdriver to remove the five (5)
screws. Arrows show the location of the screws
(Fig.7/1).