Speed Dependent Volume Control (Sdvc) - Vauxhall 2013 Corsa Infotainment system Infotainment Manual

136 Introduction
3. Press OK button and then
repeatedly n button to select
Ign. logic.
4. Press OK button to change the
current setting.
After changing the setting:
Press n button and then OK button
to leave the Settings menu.
Or:
Press one of the function buttons
TUNER, MEDIA or BC to display the
relevant function.
Automatic switch-off
The Infotainment system switches
itself off automatically after one hour
if you switch it on with the ignition off.
Setting the volume
Turn the o knob.
■ The Infotainment system plays at
the volume last set, provided the
volume was below the maximum
switch-on volume 3 138.
■ Traffic announcements and
external audio sources are inserted
at a preset minimum volume
3 138.
■ The volume of an audio source
connected via the AUX input can be
adjusted to suit the volumes of the
other audio sources (e.g. radio)
3 138.
■ If the respective source is enabled,
the volume of the traffic
announcements, the external audio
sources and the radio and CD can
be adjusted separately.
Speed dependent volume control
(SDVC)
When SDVC is activated 3 138, the
volume is adapted automatically to
make up for the road and wind noise
when driving.
External source
An external source, e.g. a mobile
phone or a navigation system, can be
connected to the Infotainment
system.
The external source is automatically
transferred through via a control
signal from the device connected,
even when the Infotainment system is
off. In this case External In is
displayed.
We recommend having appliances
installed by a Vauxhall Authorised
Repairer.
AUX input
An external audio source, e.g. a
portable CD player, can be connected
via the AUX input of your vehicle.
Stereo sound from this source is
played back via the loudspeakers of
the Infotainment system.
The connector is located in the area
of the centre console.
Always ensure that the AUX input
remains clean and dry.
For the best possible audio quality,
the external audio source should be
set to maximum volume. On units with
line-out, the output signal is available
at a fixed audio level and cannot be
changed.