U-Line U-2115WCOL-00 Installation Manual page 2

1 Overlay
Model Coverage
This guide covers the following models
U-2115WCOL-00
U-2175BEVCOL-00
U-2175BEVCOL-02
U-2175BEVCOL-60
U-2175RCGOL-00
Overlay Preparation
Use the following instructions to create or have a wood overlay
panel created for your Wine Captain® or beverage Center.
Right-hand
isometric view
shown.
Opposite
for left-hand
NOTE: Final component
is only a picture frame.
No panel inside of rails.
(Excludes -60 Models)
NOTE: Front view of
wood panel with
right-hand hinge shown
(mirror image
for left-hand hinge)
2-1/4"
3/4"
Section A-A (Excludes -60 Models)
Scale 2:1
Typ 4 places
Dimension A Table
Dimension A
Model
2115WCOL 14-3/4"
2175BEVCOL 23-3/4"
2175WCCOL
23-3/4"
2275ZWCOL 23-3/4"
U-2175WCCOL-00
U-2175WCCOL-02
U-2175WCCOL-60
U-2275ZWCOL-00
U-2275ZWCOL-60
Dim. B
A
A
Dim. A
(See Table)
Overlay Frame
IMPORTANT IMPORTANT
When having the frame or overlay finished with a stain, be
sure to finish both sides. The back side of the frame /
overlay may be visible through the glass while the door is
open in some installations.
1. Determine cabinet toe kick height. Measure the difference
between the surface the appliance will sit on and the bottom of
the adjacent cabinetry. Make note of this.
2. Create a frame or overlay using the dimensions provided in the
figure below.
Note: Dimensions will vary based on the levelness of the floor. If
floor is uneven, cut panel to the next longer dimension and adjust
level legs to achieve proper fit
3. Drill holes for pivot pins, upper door hinge and lower door
hinge as shown
See Detail A
Detail A
Scale 2:1
Detail C
Scale 2:1
3/4"
See Detail C
Dimension B Table
Toe Kick
3-3/4"
3-7/8"
4"
4-1/8"
3/8"
9/32"
Door top
Ø 3/16" x 11/16" deep
Door bottom
Ø 3/8" x 1/4" deep
Chamfer 1/32" x 45°
9/32
Dim. B Toe Kick Dim. B
29-3/4" 4 1/4" 29-3/8"
29-3/4" 4-3/8" 29-1/4"
29-5/8" 4-1/2" 29-1/4"
29-1/2"
1