U-Line Wine Captain 2075WCOL Hardware Installation Manual page 4

b. Visually check for gap between panel and glass. If there is
an objectionable gap, continue to FIGURE 3 – APPLYING
FOAM TAPE TO OVERLAY.
c. If there is little or no gap between panel and glass, continue
to FIGURE 4 – ATTACHING THE OVERLAY PANEL.
FIGURE 3 – APPLYING FOAM TAPE TO OVERLAY (IF
a. Cut the foam tape into four pieces, two pieces the width of the
overlay and two pieces the height of the overlay.
b. Remove the adhesive protection strip from one piece of the
cut foam tape and align the edge of the foam tape to the
inside edge of the overlay as shown, adhering the foam tape
to the overlay.
c. Trim each piece of tape immediately after applying it to the
overlay. Do not allow any overlapping of the foam tape.
Damage to the overlay can occur if the foam tape is not
trimmed correctly.
REQUIRED)
Figure 3
4
INSIDE
EDGE