U-Line Wine Captain 2075WCOL Hardware Installation Manual
Overlay door panel installation instructions
Hide thumbs
Also See for Wine Captain 2075WCOL:
- Specifications (2 pages) ,
- User manual (28 pages) ,
- Installation manual (16 pages)
Related Manuals for U-Line Wine Captain 2075WCOL
Summary of Contents for U-Line Wine Captain 2075WCOL
-
Page 1: Installation Instructions
Overlay Door Panel Installation Instructions for Wine Captain Models 2075WCOL and 2015WCOL U-Line Corporation • P .O. Box 245040 Milwaukee, WI 53224-9540 • Phone 414.354.0300 FAX 414.354.7905 www.U-LineService.com Printed in U.S.A. P/N 30009 (Rev. 3/03) - Page 2 OVERLAY PANEL KIT PARTS SUPPLIED Part Number Description Quantity 12041 Insert 8 mm Plug 20002 Screw #6 x 1 Pan Head 42122 Screw #6 x 1/2 Large Flat Head 35003 Foam Tape - .093 x .375 x 8'...
- Page 3 PREPARE THE NEW OVERLAY PANEL Refer to the Overlay Panel Preparation instruction sheet, part number 30010. The overlay door panel must not weigh more than 20 lbs. The thickness of the door panel must be 3/4". FIGURE 1 – REMOVE EXISTING DOOR FROM THE CABINET a.
- Page 4 b. Visually check for gap between panel and glass. If there is an objectionable gap, continue to FIGURE 3 – APPLYING FOAM TAPE TO OVERLAY. c. If there is little or no gap between panel and glass, continue to FIGURE 4 – ATTACHING THE OVERLAY PANEL. FIGURE 3 –...
- Page 5 FIGURE 4 – ATTACHING THE OVERLAY PANEL a. Tap nylon inserts into the two holes drilled in the wood panel. Use two #6 screws (P/N 42122) to attach top pivot bracket (P/N 12029) to the wood door panel (Figure 4). TOP PIVOT PLATE #6 X 5/8"...
- Page 6 FIGURES 5-6 – ATTACHING THE OVERLAY TO THE DOOR DOOR FRAME TAPE TOP OF BOTTOM OF OVERLAY OVERLAY Figure 5 a. Secure existing door with the front of the door to the back of the overlay using tape, on all four corners as shown (Figure 5).
-
Page 7: Assembling The Door
b. Place door and overlay on a clean flat protective surface. Use the door frame holes as a guide to lightly punch pilot holes for the #6 x 1" pan-head screws (see Figure 6). c. Attach the door to the overlay using the #6 x 1" wood screws. (Model 2075 shown.) If you decide to drill the pilot holes, remove the door and do not use a drill bit larger than 7/64", and do not... - Page 8 Pivot posts must be clean. Closers must also be clean and greased with petroleum jelly to ensure proper operation. a. Remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers (Figure 8). Be sure that bosses on closers align with holes in hinge and hinge plate.
- Page 9 Overlay Door Panel Preparation for Échelon Wine Captain Models 2075 and 2015 ™ The thickness of the wood overlay panel must be 3/4". 1. Use the following instructions to create or have a wood overlay panel created for your Échelon Wine Captain model as shown in Figure 1. PIVOT PLATE RELIEF FIGURE 2 NOTE...
- Page 10 3. Drill holes for pivot plate mounts, upper door hinge and lower door hinge as shown. 4. The overlay door panel must be installed in accordance with the Installation Instructions, part number 30009. U-Line Corporation P .O. Box 245040 •...