Installed Dimensions; Electrical Installation - Frigidaire 137153700B Installation Instructions Manual

Front Console Dimensions
electrical supply on rear of unit,
power cord length on gas unit
approximately 59" (150 cm)
to center of
rear vent
13 1/2"
(34.4 cm)
1"
(2.5 cm)
gas supply pipe on
2 9/16"
rear of gas unit
(6.5 cm)
47 1/2" (120.7 cm)
to clear open door

Electrical installation

The following are specifi c requirements for proper and safe
electrical installation of your dryer. Failure to follow these
instructions can create electrical shock and/or a fi re hazard.
- ELECTRICAL SHOCK HAZARD -
• This appliance MUST be properly grounded. Electrical
shock can result if the dryer is not properly grounded. Fol-
low the instructions in this manual for proper grounding.
• Do not use an extension cord with this dryer. Some ex-
tension cords are not designed to withstand the amounts
of electrical current this dryer utilizes and can melt, creat-
ing electrical shock and/or fi re hazard. Locate the dryer
within reach of the receptacle for the length power cord
to be purchased, allowing some slack in the cord. Refer
to the pre-installation requirements in this manual for the
proper power cord to be purchased.
under-counter
installation height
(91.5 cm)
34 5/8"
(87.9 cm)
center line
height for
rear vent
3 3/4"
(9.5 cm)
4 3/8"
(11 cm)
optional vent
3 3/4"
knockout
(9.5 cm)
27" (68.6 cm)
Rear Console Dimensions
electrical supply on rear of unit,
power cord length on gas unit
36"
approximately 59" (150 cm)
to center of
(34.4 cm)
1"
(2.5 cm)
2 9/16"
(6.5 cm)
- ELECTRICAL SHOCK HAZARD -
• A U.L.-approved strain relief must be installed onto pow-
er cord. If the strain relief is not attached, the cord can be
pulled out of the dryer and can be cut by any movement
of the cord, resulting in electrical shock.
• Do not use an aluminum wired receptacle with a copper
wired power cord and plug (or vice versa). A chemical
reaction occurs between copper and aluminum and can
cause electrical shorts. The proper wiring and receptacle
is a copper wired power cord with a copper wired recep-
tacle.
Dryers operating on 208 volt power supply will have
longer drying times than dryers operating on 240 volt power
supply.
8
rear vent
center line
13 1/2"
height for
rear vent
3 3/4"
(9.5 cm)
gas supply pipe on
rear of gas unit
47 1/2" (120.7 cm)
to clear open door
optional vent
knockout
27" (68.6 cm)
43 5/8"
(111 cm)
36"
(91.5 cm)
4 3/8"
(11 cm)
3 3/4"
(9.5 cm)