Changing The Printer Operation Mode - Canon iP3600 SERIES On-Screen Manual

Changing the Printer Operation Mode

> Changing the Printer Settings
Advanced Guide
Operation Mode
Changing the Printer Operation Mode
This function allows you to switch between various modes of printer operation.
The procedure for changing the printer settings is as follows:
Custom Settings
Open the printer driver setup window
1.
Make sure that the printer is on, and then click Custom Settings on the Maintenance
2.
tab
The Custom Settings dialog box opens.
Note
If the printer is off or bi-directional communication is disabled, a message may appear
because the computer cannot collect the printer status.
If this happens, click OK to display the most recent settings specified on your computer.
If necessary, complete the following settings:
3.
Prevent paper abrasion
The printer can increase the gap between the print head and the paper during high-density printing
to prevent paper abrasion.
Check this check box to use this function.
Ink Drying Wait Time
You can set the length of the printer rest time until printing of the next page begins. Moving the slider
to the right increases the pause time and moving the slider to the left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the printed page dries,
increase the ink drying wait time.
Reducing the ink drying wait time speeds up printing.
Transmit the settings
4.
Click Send. When the confirmation message appears, click OK.
The printer runs in the changed mode hereafter.
>
Changing Printer Settings from Your Computer
Стр. 292 из 366 стр.
> Changing the Printer
Page top