Cadillac SRX Owner's Manual page 290

8. Push on the lamp side opposite
the clip until the lamp assembly
snaps into place.
Back-up Lamp
Daytime
Running Lamp
Headlamp
High-Beam
Headlamp
Low-Beam
License Plate Lamp
Turn Signal Front
Tail/Turn
Signal Rear
For replacement bulbs not listed
here, contact your dealer.
The vehicle has fuses and circuit
breakers to protect against an
electrical system overload.
Hyperclick
When the current electrical load is
PH16W
too heavy, the circuit breaker opens
7443 ULL
and closes, protecting the circuit
until the current load returns to
normal or the problem is fixed. This
9005LL
greatly reduces the chance of circuit
overload and fire caused by
H11LL
electrical problems.
Fuses and circuit breakers protect
W5WLL
power devices in the vehicle.
7444NA
Replace a bad fuse with a new one
of the identical size and rating.
7440
If there is a problem on the road and
a fuse needs to be replaced, the
same amperage fuse can be
borrowed. Choose some feature of
the vehicle that is not needed to use
and replace it as soon as possible.
An electrical overload may cause
the lamps to go on and off, or in
some cases to remain off. Have the
headlamp wiring checked right away
if the lamps go on and off or
remain off.
If the wiper motor overheats due to
heavy snow or ice, the windshield
wipers will stop until the motor cools
and will then restart.
Although the circuit is protected
from electrical overload, overload
due to heavy snow or ice may
cause wiper linkage damage.
Always clear ice and heavy snow
from the windshield before using the
windshield wipers.
If the overload is caused by an
electrical problem and not snow or
ice, be sure to get it fixed.