Increasing Speed While Acc Is At A Set Speed; Selecting The Follow Distance; Reducing Speed While Acc Is At A Set Speed - Cadillac SRX Owner's Manual

9-40 Driving and Operating
To begin using ACC again, move
the control up toward +RES briefly.
The vehicle returns to the previous
set speed.
Increasing Speed While ACC is at
a Set Speed
If ACC is already activated, do one
of the following:
Use the accelerator to get to the
higher speed. Move the control
toward SET , then release it and
the accelerator pedal. The
vehicle will now cruise at the
higher speed.
When the accelerator pedal is
pressed, ACC will not brake
because it is overridden.
A warning message will appear
on the Driver Information Center
(DIC). See
Move the control toward +RES
and hold until the desired set
speed appears on the display,
then release it.
To increase vehicle speed in
small amounts, move the control
toward +RES and then release
it. Each time this is done, the
vehicle goes 1.6 km/h (1 mph)
faster.
When it is determined that there is
no vehicle in front of your vehicle
slower than the set speed, then the
vehicle speed will increase to the
set speed.
Reducing Speed While ACC is at a
Set Speed
If ACC is already activated, do one
of the following:
Use the brake to get to the
desired lower speed. Move the
control toward SET and release
the accelerator pedal. The
vehicle will now cruise at the
lower speed.
.
Move the control toward
SET and hold until the desired
lower speed is reached, then
release it.
To decrease the vehicle speed in
small amounts, move the control
toward SET briefly. Each time
this is done, the vehicle goes
about 1.6 km/h (1 mph) slower.

Selecting the Follow Distance

When a slower moving vehicle is
detected ahead, ACC will adjust the
vehicle's speed and attempt to
maintain the follow distance gap
selected.
Press on the steering wheel to
adjust the following gap. Each press
cycles the gap button through three
settings: Far, Medium, or Near.
When pressed, the current gap
setting displays briefly on the
instrument cluster. The gap setting
will be maintained until it is
changed.