Improving The Print Quality - Brother DCP-7055 Basic User's Manual

Improving the print quality

If you have a print quality problem, make a copy first (put a document on the scanner glass and
press Start). If the printout looks good, the problem is probably not the machine. Check the
interface cable connections or try printing a different document. If the printout or test page printed
from the machine has a quality problem, check the following steps first. And then, if you still have
a print quality problem, check the chart below and follow the recommendations.
Note
Brother does not recommend the use of cartridges other than Brother Original cartridges or the
refilling of used cartridges with toner from other sources.
a
To get the best print quality, we suggest using the recommended paper. Check that you use
paper that meets our specifications. (See Acceptable paper and other print media
on page 17.)
b
Check that the drum unit and toner cartridge assembly is installed correctly.
Examples of poor print quality
ABCDEFGH CDEF
abcdefghijk defg
A B C D B C
a b c d e b c d
0 1 2 3 4 2 3
Faint
Recommendation
 Take out the drum unit and toner cartridge assembly. Hold the
assembly level with both hands and gently shake it from side to
side several times to spread the toner evenly inside the cartridge.
 Check if the Toner Setting in Replace Toner is set to
Continue (Continue mode). See Toner settings in Chapter 1 of
the Advanced User's Guide.
'
 Check the machine s environment. Conditions such as humidity,
high temperatures, and so on, may cause this print fault. See the
Safety and Legal booklet.
 If the whole page is too light, Toner Save mode may be on. Turn
off Toner Save mode in the machine menu settings or Toner
Save mode in the printer Properties of the driver. See Toner save
in Chapter 1 of the Advanced User's Guide or Advanced tab in
Chapter 2 of the Software User's Guide.
Clean the corona wire of the drum unit. See Cleaning the corona

wire on page 42.
 Put in a new toner cartridge. See Replacing the toner cartridge
on page 29.
 Put in a new drum unit. See Replacing the drum unit on page 35.
Troubleshooting
B
B
69