Operation - Bosch DAF220 Original Instructions Manual

daf220_bu_2609140572_003.fm Seite 10 Montag, 8. September 2008 2:22 14
10 |
Exiting Special Modes
A press of 11 ON/CLEAR/OFF for
less than 1 second while the tool is
in the SIMPLE MTR or COMPOUND
MTR modes (or when HOLD [mem-
ory] is flashing) returns the tool to
the normal measuring mode.

Operation

Normal Measuring Mode –
Measuring the Angle of
Structure or Workpiece
(See Figure D–F)
1 Place both legs flat on the sur-
faces adjacent to the angle.
2 The "tool-interior angle" w (the
angle between the main leg 6 and
the adjustable leg 2) is measured.
3 The angle measurement in
degrees is shown in the display.
Notes:
– Contact surfaces and contact
edges must be clean. A dirty
surface will cause erroneous
measurements.
– For increased ability to see the
measurement, there are displays
on both the front and back sides
of the tool.
– When the angle between the
legs is changed, the angle mea-
surement displayed is automati-
cally updated.
Using the Leg Extension
(Optional Attachment)
The leg extension makes it possible
to measure convex angles when
one of the contact surface areas is
too short to accommodate the
length of the legs.
– Slide the leg extension 14 onto
the adjustable leg 2 in the direc-
tion indicated by the arrow on
the extension.
2 609 140 572 | (8.9.08) Bosch Power Tools