Frigidaire 5-10 Use And Care Manual page 9

Air Conditioner Features
(continued)
HEATING FEATURE
Temp/Timer
Auto Temp
Hi
Med
Lo
Heat
Cool
Fan
Speed
Energy Saver
Fan Only
Temp/Timer
Mode
Timer
Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the "Heat" Mode, the
fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 55°F
(13°C) and 80°F (27°C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample
the room air.
TO TURN UNIT OFF:
Temp/Timer
Auto Temp
Hi
Med
Lo
Heat
Cool
Fan
Speed
Energy Saver
Fan Only
Temp/Timer
Mode
Timer
FAULT CODES
T e m p /T i m e r
Auto Temp
Hi
Med
L o
Heat
C ool
F a n
S p e e d
E nergy S aver
Fan Only
T e m p /T i m e r
M o d e
T i m e r
If the display reads "AS", a sensor
has failed. Contact your Authorized
Frigidaire Service Center
Now that you have mastered the operating procedure, here are more features in your control that you should know.
?
The Remote Control will operate all the control panel features, follow the same instructions.
!
?
The "Cool "circuit has an automatic3 minute time delayed start if the unit is turned off
and on quickly. This prevents overheating of the compressor and possible circuit
breaker tripping. The fan will continue to run during this time.
?
The control will maintain any set temperature between 60F and 90F degrees (cooling), 55F and 80F (heating).
?
The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from
one to the other, press and hold the Up and Down Temperature Selection Pads at the same time for 3
seconds.
:
(on some models)
Check
Sleep
Filter
Remote
Sensing
Check
Sleep
Filter
ON/OFF BUTTOT
Remote
Sensing
L o
C h e c k
S l e e p
F i l t e r
F a n
S p e e d
Fan Only
R e m o te
S e n s i n g
M o d e
If the display reads "HS", a sensor
has failed. Contact your Authorized
Frigidaire Service Center
ADDITIONAL THINGS YOU SHOULD KNOW
DO THIS:
PRESS
MODE BUTTON
SELECT HEAT
DO THIS:
PRESS
T e m p /T i m e r
Auto Temp
Hi
Med
S l e e p
Heat
C ool
E nergy S aver
T e m p /T i m e r
R e m o te
S e n s in g
T i m e r
9
YOU WILL SEE:
Auto Temp
Hi
Med
Lo
Heat
Cool
Fan
Speed
Energy Saver
Fan Only
Mode
YOU WILL SEE:
Auto Temp
Hi
Med
Lo
Heat
Cool
Fan
Speed
Energy Saver
Fan Only
Mode
Auto Temp
Hi
Med
L o
C h e c k
F i l t e r
Heat
C ool
F a n
S p e e d
E nergy S aver
Fan Only
M o d e
If the display reads "ES", a sensor
has failed. Contact your Authorized
Frigidaire Service Center
Temp/Timer
Check
Sleep
Filter
Temp/Timer
Remote
Sensing
Timer
Temp/Timer
Check
Sleep
Filter
Temp/Timer
Remote
Sensing
Timer
T e m p /T i m e r
C h e c k
S l e e p
F i l t e r
T e m p /T i m e r
R e m o te
S e n s in g
T i m e r
!