Baby Lock Urity BLTY Instruction And Reference Manual page 301

n
Using a hand sewing needle such as a
ribbon embroidering needle, pull the
bobbin thread to the top (wrong side) of the
fabric, and then tie the upper thread and
the bobbin thread together.
Memo
• If there is a gap between the start point and
end point of the pattern, leave an adequate
length of thread, cut the threads, and
remove the fabric from the machine. Use a
ribbon embroidering needle to hand sew
stitches to connect the starting and ending
points.
o
Remove the fabric from the embroidery
frame, and check the finished embroidery.
a Right side of fabric
p
If the desired results could not be achieved,
adjust the tension of the bobbin thread and
the upper thread, and then try
embroidering the pattern again.
For more details, refer to "ADJUSTING THE THREAD
TENSION" on page E-96.
Memo
• Check bobbin after each bobbin work
pattern is embroidered to make sure there
is adequate bobbin thread for the next
pattern.
• While selecting the bobbin work pattern, the
embroidery speed value is set to "100
spm". Refer to "Adjusting the Embroidery
Speed" on page E-33 to change the
embroidery speed.
b Wrong side of fabric
CREATING BOBBIN WORK
Embroidering E-95
E
3