Table of Contents
Advertisement
Marks
This key does not operate when the needle is down. Raise the
needle and press the key again.
This pattern cannot be sewn with this mode.
This stitch is not "Dual Feed Mode" compatible.
This USB media cannot be used.
This USB media is incompatible.
Transmitting by USB
Turn off the power and replace the needle plate.
USB media error
USB media is not loaded. Load USB media.
Use the presser foot lifter button to lower the presser foot.
When the speed controller is set to control the zigzag stitch
width, the "Start/Stop" button does not operate.
SPECIFICATIONS
Sewing Machine and Accessories
(Box 1 of 2)
Extension table box
(Box 2 of 2)
Total Shipping Weight (Combination of 2 boxes complete)
*
Please be aware that some specifications may change without notice.
Error Messages
Item
Dimensions of machine
Dimensions of box
Weight of machine
Weight of box (for shipping)
Sewing speed
Needles
Dimensions of extension table
Dimensions of machine with extension
table attached
Dimensions of box
Weight of extension table
Weight of box (for shipping)
Cause/Solution
This message is displayed when a key on the LCD display is
touched while the needle is in the down position.
This message is displayed when the selected stitch is not
available for the specific function.
This message appears when the dual feed foot cannot be used
with the current stitch. Select other stitch. (see page B-55)
This message is displayed when you try to use incompatible
media.
This message is displayed when you try to use incompatible
USB media. For a list of compatible USB media, visit
" www.babylock.com ".
This message is displayed while the USB media is
transmitting.
This message is displayed when you try to sew with a stitch
other than a middle needle position stitch while the single-hole
needle plate is installed.
This message is displayed when an error occurs with the USB
media.
This message is displayed when you try to recall or save a
pattern while no USB media is loaded.
This message is displayed when a button, such as the
"Start/Stop" button, is pushed while the presser foot is raised.
This message is displayed when the speed control lever is set
to control the zigzag stitch width, and the "Start/Stop" button
is pushed. Use the foot controller to operate the machine.
Specification
Approx. 57.1 cm (W) × 33.5 cm (H) × 28.4 cm (D) (approx.
22-1/2 inches (W) × 13-1/16 inches (H) × 11-3/16 inches (D))
Approx. 68.5 cm (W) × 55.0 cm (H) × 37.7 cm (D) (approx.
26-15/16 inches (W) × 21-5/8 inches (H) × 14-13/16 inches
(D))
Approx. 15.4 kg (approx. 33.9 lb)
Approx. 22.0 kg (approx. 48.5 lb)
70 to 1050 stitches per minute
Home sewing machine needles (HA × 130)
Approx. 63.6 cm (W) × 9.8 cm (H) × 40.6 cm (D) (approx.
25-1/16 inches (W) × 3-7/8 inches (H) × 16 inches (D))
Approx. 81.1 cm (W) × 33.5 cm (H) × 40.6 cm (D) (approx.
32-1/16 inches (W) × 13-1/16 inches (H) × 16 inches (D))
Approx. 66.3 cm (W) × 42.7 cm (H) × 5.8 cm (D) (approx.
25-1/16 inches (W) × 16-13/16 inches (H) × 2-5/16 inches (D))
Approx. 2.2 kg (approx. 4.9 lb)
Approx. 3.0 kg (approx. 6.7 lb)
Approx. 27 kg (approx. 59.6 lb)
SPECIFICATIONS
A
1
Appendix A-19
Advertisement
Chapters
Table of Contents
Troubleshooting
