Axminster AW106PT2 User Manual page 14

Parts Identification & Description...
W
A X M I N S T E R
W H I T E
Autofeed engage This handled lever protrudes through the cabinet to the left of the infeed
control
Fence assembly This assembly consists of a base plate onto which a vertical 'T' yoke is
Note. Electrical Interlocks The machine is electrically interlocked in the two modes.
1.Overhand
planing.
2. Thicknessing.
It is not possible to run the machine in a 'half and half' configuration.
14
side of the thicknessing table. It is sprung loaded to keep it in position
against a 'gate' location. The two position 'gate' selects either the feed
engaged or disengaged.
mounted. The ends of the yoke arms are bossed and have a threaded hole
in hole in them. The rear of the fence has two slotted lugs that span the yoke
bosses. Two clamp bolts and washers, secure the fence, through its slotted
lugs into the threaded holes in the bosses of the yoke. The reason for the
slots is to allow the fence to be manoeuvred in 'tilt' to allow any angle (up to
45 degrees) to be set on the fence. A presetting bolt is threaded through the
main body of the yoke, and impinges on the rear surface of the fence to
enable the 'upright' position to be set quickly and easily.
The outfeed and infeed tables must be down. The dust extraction
hood must be below the table, acting as a lower guard and chip
collector.
The outfeed and infeed table must be raised. The dust extraction
hood must be over the table, acting as the upper guard and chip
collector.
The machine must be in one configuration or the other.
FREEPHONE
0800 371822