I/O Terminal Connectors - Axis 233D User Manual

AXIS 233D - I/O terminal Connectors
56

I/O terminal Connectors

The AXIS 233D Network Dome Camera has three (8 pin) connectors. The inputs/outputs are
used in applications for example, event triggering, time lapse recording, alarm notification
via email, picture storage to FTP locations etc.
• Power, auxiliary power, GND and audio.
• Four solid state relay outputs - these can drive a maximum load of 50VDC or
35VAC at 500mA directly or heavier loads by connecting additional relay cir-
cuitry. If the output is used with an external relay, a diode must be connected in
parallel with the load for protection against voltage transients.
• Four alarm inputs - Used for connecting external alarm devices and triggering
images for specific alarm-based events. The input is typically connected to a
motion detector or any other external security device, and images can be
uploaded whenever the detector is activated. A maximum 40VDC is allowed on
the inputs.
Network
connector
Power/Audio
Outputs
Inputs