Horizon Fitness ELITE 3.2E User Manual page 5

A SS EM BLY ST EP 2
HARDWARE BAG FOR STEP 2 CONTENTS :
���������������
�����
������
����������
������������
A SS EM BLY ST EP 3
HARDWARE BAG FOR STEP 3 CONTENTS :
����������
������������
����������
8
Elite 3.2E 4.2E Elliptical Rev 1.0.indd 8-9
��������
�����
������
A) Open HARDWARE BAG FOR STEP 2.
B) Slide left and right FOOT LEVELERS
onto MAIN FRAME.
���������������
C) Attach FOOT LEVELERS using
WASHER (E) and BOLT (F).
��������
�����
�������
�����������������������
������
����������
������
�����������������
�����
������
A) Open HARDWARE BAG FOR STEP 3.
B) Slide TEFLON SHEET WASHER (G),
�������������
PEDAL ARM and TEFLON WASHER
�����������������
(H) over PEDAL ARM BRACKET
C) Secure PEDAL ARM to PIVOT TUBE,
���������
using NYLON NUT (I).
D) Attach PEDAL ARM COVER using
SCREW (J).
���������������
E) Repeat on other side.
���������
ASSEMBLY STEP 4
������������
WARNING
���������
HARDWARE BAG FOR STEP 4 CONTENTS :
�����
������
���������
�����
������
4.2E ONLY
���������
���������
NOTE: There is NO hardware for steps
A-D. All hardware is pre-installed.
���������������
A) Remove PRE-ATTACHED BOLT &
�����
WASHERS from CONSOLE MAST.
������������
����������
���
B) Slide LOWER HANDLEBAR onto
CONSOLE MAST and attach by re-
inserting PRE-ATTACHED BOLT &
WASHER.
������������
�������������
C) Slide UPPER HANDLEBAR onto
LOWER HANDLEBAR and align
�����
���������
NOTCH with TAB making sure
handlebars are joined together
completely. Secure UPPER
HANDLEBAR to LOWER HANDLEBAR
using PRE-ATTACHED SET SCREWS.
D) Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
4.2E ONLY
��������
�����
������
4.2E only
E) Open HARDWARE BAG FOR STEP 4.
���������
F) Attach FRONT & BACK HANDLEBAR
COVERS using 2 SCREWS (K) and 2
BOLTS (L) for each side.
���������
������
9
7/13/05 2:47:56 PM