Pioneer XW-NAS3 Operating Instructions Manual page 12

03 iPod playback
Important
If the power indicator and iPod indicator flash
simultaneously, a connection fault is
indicated. Perform the following
troubleshooting checks:
• Check whether the iPod was supported by
this unit.
• Reconnect the iPod to the unit. If this
doesn't seem to work, try resetting your
iPod.
• Update the iPod software to the latest
version.
If the iPod cannot be operated, check the
following items:
• Is the iPod connected correctly?
Reconnect the iPod to the unit.
• Is the iPod experiencing a hangup? Try
resetting the iPod, and reconnect it to the
unit.
12
En
Tip
• iPod recharging occurs whenever an iPod
is connected to this unit. (This function is
supported in standby mode as well.)
• Whenever an iPod is connected to this
unit, turning the unit's power ON or
switching input to iPod will cause iPod
playback to begin automatically.
• When input is switched from iPod to
another function, the iPod playback stops
automatically.
• If the unit is set to standby when an iPod is
connected, the iPod's power will be turned
OFF automatically.