Philips ShowView DVDR70 Operating Instructions Manual page 71

Programming a recording (TIMER)
Thanks to this programming system, you no longer need to tediously enter the date, programme
number, start and end times. All the information needed by the DVD recorder for programming
is contained in the ShowView
most TV listings magazine.
1
Switch on the TV set. If required, select the programme number for
the DVD recorder.
2
Press TIMER on the remote control.
The programming method selected last is marked.
3
Select '
with C .
4
Enter the entire ShowView number. This number is up to 9 digits long
and can be found next to the start time of the TV programme in your
TV listings magazine.
e.g.: 5-312-4 or 5,312 4
Enter 53124 for the ShowView-number.
If you make a mistake, you can clear your instructions with CLEAR .
Using SELECT , select from the following options:
: Repeated daily recordings (Monday to Friday).
: Repeated weekly recordings (every week on the same day).
5
Confirm with OK .
a
b The programme number of the TV channel has not yet been assigned to
the ShowView number. Use C , D or the number buttons 0..9 on the
remote control to select the appropriate programme number (name) of the
TV channel and confirm with OK .
a
b The entered ShowView number is incorrect. Correct your entry or cancel
using the SYSTEM-MENU button.
b Check the time/date (see 'Setting the time & date' in 'Installing your DVD
recorder').
a
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
® programming number. This 9-digit ShowView
' using CH- B or CH+ A and confirm
® number is found in