Storage After Use - Echo CS-310 Instruction Manual

Warm weather
position
• Inspect and adjust every part of the chain saw.
- Completely clean every part and repair if neces-
sary.
- Apply thin coating of oil on metal parts to prevent
rust.
• Remove chain and guide bar.
• Drain fuel tank completely. Press purge bulb 6 - 7
times to remove remaining fuel from carburetor then
drain the tank again. Close choke, start and run the
engine until it stops due to lack of fuel.
• Allow engine to cool then remove the spark plug and
pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine
oil into the cylinder through the spark plug hole.
• Store in a dry area, free from dust.
CS-310
Plug
Cylinder
cover
Cold weather
"storage" position

STORAGE AFTER USE

WINTER OPERATION
Use the winter plug to prevent carburetor trouble in
winter.
• Release the cylinder cover latches and remove cylin-
der cover. Remove plug from warm weather position,
and install into cold weather "storage" position.
NOTE
For operation at normal temperature return the plug
to its original place. (5°C, 41°F)
It causes over heating of the engine.
WARNING
Do not store in an enclosure where fuel fumes may
accumlate or reach an open flame or spark.
CAUTION
Do not lend or rent your chain saw without the
Instruction manual and Safety manual.
NOTE
• For future reference, you should keep this Instruction
manual and the Safety manual.
• If this Instruction manual or the Safety manual has
become illegible or is lost, please purchase a new
one from your ECHO dealer.
32