Preparation For Use; Guide Bar/Saw Chain Installation/Removal - Echo CS-310 Instruction Manual

(A)
(D)
(E)
(F)
Clutch
Adjuster pin

PREPARATION FOR USE

(B)
(C)
Two nuts
Clutch cover
Guide bar studs
Guide bar
adjuster
hole
Nuts
Clutch cover
WARNING
Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.
nOTE
The machine may be delivered with guide bar,
tip guard, and saw chain separated. Install
guide bar, tip guard, and saw chain as follows.
KICK GUARD
TIONS
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
and through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16
in.) wrenches until snug. Make certain Kick
Guard is flush against guide bar.
®
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
guide bar.
GUIDE BAR AND SAW CHAIN IN-
STALLATION/REMOVAL
nOTE
• Move the chain brake lever (Front Hand Guard)
fully rearward to remove or install the clutch cover
to chain saw.
• Align the brake connector of the clutch cover to the
groove on the side of the brake lever.
1. Release the cylinder cover latches, and remove the
cylinder cover.
2. Remove spark plug lead.
3. Remove two clutch cover nuts and remove clutch
cover.
4. Remove bar and saw chain if necessary. See "Main-
tenance and Care" section for guide bar/saw chain
maintenance procedures.
13
TO BAR INSTRUC-
®
P/N 2894901 and
®
®
is tight on
®
®
must
CS-310