Echo Pro Attachment Series PAS-265 Operator's Manual page 8

8
1. POWER hEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.
2. SPARK ARRESTOR MUFFLER OR SPARK ARRESTOR MUFFLER WITh CATALyST -The muffler or
catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of
carbon from leaving the muffler. Keep exhaust area clear of flammable debris.
3. FUEL TANK - Contains fuel and fuel filter.
4. FUEL TANK CAP - Covers and seals fuel tank opening.
5. RECOIL STARTER hANDLE - Pull handle slowly until recoil starter engages, then quickly and firmly. When
engine starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.
6. PURGE bULb - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging air from
the carburetor. Pump purge bulb until fuel is visible and flows freely in the clear fuel tank return line. Pump purge
bulb an additional 4 or 5 times.
7. AIR CLEANER - Contains replaceable filter element.
8. ChOKE - The choke control lever is located on the top of the air cleaner case. Move choke lever to COLD START
( ) position to close choke for cold starting. Move choke lever to the RUN (
9. SPARK PLUG - Provides spark to ignite fuel mixture.
10. TOP GUARD - Protects arm from the hot engine.
11. DRIVE ShAFT COUPLER - Includes Locator Pin and Clamping Knob.
12. FRONT hANDLE - The Front Handle is assembled to the Upper Drive Shaft assembly and must be positioned for
proper cutting attitude and operator comfort.
13. STOP SWITCh - "SLIDE SWITCH" mounted on top of the Throttle Trigger Housing. Move switch FORWARD
to RUN, BACK to STOP.
14. ThROTTLE TRIGGER LOCKOUT - This lever must be held during aceleration. Operation of the throttle trigger
is prevented unless throttle trigger lockout lever is depressed.
15. GRIP - Rear (right hand) handle.
16. ThROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, press trigger gradu-
ally for best operating technique.
17. UPPER DRIVE ShAFT ASSEMbLy - Includes the Rear (Right Hand) Handle Assembly, Front (Left Hand)
Handle Assembly, Flexible Drive Cable, Drive Shaft Assembly Coupler and Power Head.
18. bARRIER bAR - Helps keep the cutting attachment away from the operator's legs and feet by limiting rearward
movement of the unit if kick out occurs. Not for use as a handle. Allows use of all Echo-approved accessories and
attachments.
) position to open choke.