Table of Contents
Advertisement
WARNING
IMPROPER CLUTCH COVER ASSEMBLY CAN RE-
SULT IN SERIOUS INJURY, AND WILL CAUSE SE-
VERE SAW DAMAGE IF UNIT IS STARTED. NEVER
START OR OPERATE SAW IF BRAKE BAND IS NOT
IN PLACE ON CLUTCH DRUM. ALWAYS CHECK
CHAIN BRAKE OPERATION AFTER REPLACING
COVER. DO NOT USE SAW IF CHAIN BRAKE DOES
NOT FUNCTION PROPERLY.
p
RepaRation foR
kiCk GuaRD
For saws with Kick Guard
cal or asymmetrical low-kick type guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
through front hole (C) in guide bar.
2. IMPORTANT: Dimple in Kick Guard
recess in guide bar (E).
3. Tighten nut (F) and bolt (A) until snug. Make certain
Kick Guard
GuiDe baR anD saw Chain
Remove
H
Saw Chain is sharp! Always wear gloves when handling
assembly, otherwise serious personal injury may result.
NOTE
Move chain brake lever fully rearward to remove or install
clutch cover to saw.
I
IMPORTANT
Always loosen guide bar nuts before turning chain
J
tension adjuster, otherwise clutch cover and tensioner
will be damaged.
1. Remove spark plug lead.
2. Remove two guide bar nuts and remove guide bar cover.
Turn tension adjustment screw counterclockwise 2 to 3
turns if bar and chain are installed.
3. Remove guide bar and saw chain if necessary.
NOTE: See "MAINTENANCE AND CARE" instructions
for guide bar, sprocket, and saw chain maintenance.
4. Mount guide bar (G) on studs, and slide toward sprocket
to make saw chain installation easier.
5. Install saw chain (H) as shown, with cutters on top of
guide bar facing forward.
6. Align holes of clutch cover (J) with guide bar studs,
and tensioner pin (I) with lower guide bar adjuster hole.
7. Turn saw over and check brake band for correct posi-
tion around clutch drum. If brake band is not in place
around drum, remove clutch cover, make sure brake is
released, and reinstall.
9
u
se
®
to baR instRuCtions
®
P/N 2894901 and symmetri-
®
is flush against guide bar.
WARNING
®
and
®
(D) must engage
-
/
install
DANGER
Hide quick links:
Advertisement
Table of Contents
