Table of Contents
Advertisement
UR-1
The UR-1 has a rotary encoder and a function button to
fit a single-gang decora plate, and mounts in a single-gang
electrical box.
UR-1
The encoder is used to increase or decrease the volume of
an input or output. A ring of 15 LEDs surrounding the encoder
indicates the relative audio level. The function button can be
programmed for a number of actions, such as "Mute an Input"
or "Recall a Priority." When the function is activated, the LED in
the button lights. Programming is done in the Remotes window
of DX Navigator.
UR-2
The UR-2 has four function buttons to fit a single-gang
decora plate, and mounts in a single-gang electrical box.
Each button can be programmed to perform a different action.
When a function is activated, the LED in the button lights.
Programming is done in the Remotes window of DX Navigator.
UR-2
10
– DX1208
AC POWER CONSIDERATIONS
The DX1208 has a built-in universal power supply and
can accept an AC voltage ranging from 100 V to 240 V. Each
DX1208 draws an average of 0.5 amps of AC line current at
120 VAC.
Warning: Always use a 3-conductor AC power cord with
a safety ground connection. Never remove the ground pin or
attempt to bypass it. This is very dangerous.
4. SOFTWARE INSTALLATION
The DX Navigator software application is provided on a CD-
ROM, which can be installed on a PC. It provides a graphical
user interface (GUI) for controlling the digital signal processing
(DSP) for multiple DX Series products, including the DX1208.
Check our website at www.eaw.com for software upgrades
as they become available.
COMPUTER REQUIREMENTS
DX Navigator requires an IBM compatible PC with the
Windows XP SP2 and above or Windows Vista operating
system. It is not designed to work with previous versions of
Windows or Macintosh operating systems.
INSTALLING THE DRIVERS AND
DX NAVIGATOR
During the installation process, USB drivers are installed on
your computer's hard drive. USB drivers are necessary for the
computer to communicate with the DX1208 over the USB port.
This software installation is a two-step process and requires
running the New Hardware Wizard twice.
To install the software on a PC:
1. Make sure no other applications are running.
2. Insert the DX1208 CD into your PC's CD drive, or download
the software from www.eaw.com.
3. Click "Start > Run > Browse" and navigate to the CD drive
or the location on your hard drive where the file was
downloaded.
4. Double-click "DXNavigator_v1_xxx.exe (where xxx is the
revision level of the installation).
5. Click "OK" in the Run window.
Hide quick links:
Advertisement
Table of Contents
