Introduction; Installation; Unpacking And Inspection; Installation Procedure - EAW AC-TX64 Instruction Manual & Cooking Manual

2. INTRODUCTION

Congratulations on the purchase of your new EAW Commercial 70 Volt/100 Volt
transformer panel. These panels allow you to configure the VR Series Loudspeakers and the
CLA37 Column Loudspeaker for use in 70 Volt or 100 Volt distributed systems.
• The AC-TX64 transformer panel can be used in the VR61, VR62 or CLA37
Loudspeakers, in place of the input terminal plate.
• The AC-TX128 transformer panel can be used in the VR21 or VR51 Loudspeakers.

3. INSTALLATION

Unpacking and Inspection

Visually inspect the outside of the shipping carton and check for any shipping damage.
After unpacking, if you find concealed damage, save the packing materials for the carrier's
inspection, notify the carrier immediately, and file a shipping damage claim. Although EAW
Commercial will help in any way possible, it is always the responsibility of the receiving
party to file any shipping damage claim. The carrier will help prepare and file this claim.

Installation Procedure

1. Remove any external speaker wires
from your Loudspeaker's input
terminals, and remove the six screws
securing the input panel.
2. Remove the internal wires from the
back of the input panel, and put the
input panel in a safe place for future
use.
3. Connect the Positive (white) wire
from the Loudspeaker to the white
wire from the transformer.
4. Connect the Negative (black) wire
from the Loudspeaker to the black
wire from the transformer.
5. Fit the transformer panel to the
Loudspeaker, with the transformer
inside, and secure using the six
screws from step 1. Make sure
the two wires are not accidentally
pinched.
NOTE: For the CLA37, the
transformer panel must be installed
upside down, so the transformer is
at the top, and does not interfere
with the CLA37 drivers.
AC-TX64 and AC-TX128 –
WHITE
BLACK
3