DSC Classic PC585 Instruction Manual page 9

Additional Codes
Up to 32 additional access codes (01 through 32) may be programmed.
To program a new code:
Enter [ ][5][Master Code][code number 01 to 32][new access code]. The code number is a double digit
from 01 to 32. Access codes must be four digits unless otherwise indicated by your installer. Enter digits
0 through 9 only. Press [#] to return to the Ready state.
If an access code already exists for the code number you have selected, it will be replaced by the new
code. Be sure to record your new code(s) on the "System Information" page in this book.
To erase a code:
Enter [ ][5][Master Code][code number 01 to 32][ ]. Press [#] to return to the Ready state. The Master
code cannot be erased.
Programming codes from an LCD Keypad:
Master Code
Press the [ ] key to enter the function list. Scroll (< >) to...
Press [5] or [ ]. The display will read...
Press (*) for <>
Access Codes
Enter your current Master Code. The display will read...
Enter Master
Access Code
"40P" represents the Master Code. Press the [ ] key to indicate that you wish to
(*) to Edit <>
program the Master Code. The display will read...
User Code 40P
Enter the new Master Code. The Master Code must be four digits unless otherwise
Enter New Code
indicated by your installer. Enter digits 0 through 9 only. Once the new code is
1234 <>
entered, the keypad will beep 3 times and the display will read...
Press [#] to exit the code programming function.
(*) to Edit <>
User Code 40P
Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We
recommend that the factory default Master Code [1234] not be used.
Additional Access Codes
To erase, add or change a user code, press [ ] to enter the functions list. Use the arrow (< >) keys to
scroll to the following message...
Press [ ]. Display will read...
Press (*) for <>
Access Codes
Enter the Master Code. Display will read...
Enter Master
Access Code
Use the scroll keys (< >) to find the access code – indicated by "01P" to "32P" – you
[*] to Edit <>
wish to add, change or delete. Press the [ ] key to select the code you wish to alter.
User Code 01P
The display will read...
To add or change a code, enter the new code. Access codes must be four digits
Enter New Code
unless otherwise indicated by your installer. Enter digits 0 through 9 only. To delete an
1234 <>
access code, enter [ ]. Once the 4 digit code or [ ] has been entered, the keypad
sounder will beep 3 times and the display will read...
The "P" means the code has been programmed. If there is no "P" then that code is deleted.
[*] to Edit <>
Press [#] to exit the code programming function. The Master code cannot be erased.
User Code 01P
Remember to record your new code(s) on the "System Information" page in this booklet.
7