DSC Impassa User Manual page 5

Always ensure you obtain the latest version of the User Guide. Updated versions of this User Guide are
available by contacting your distributor.
To reduce the risk of fire, electric shock and/or injury, observe the following:
• Do not spill any type of liquid on the equipment.
• Do not attempt to service this product yourself. Opening or removing the cover may expose you to
dangerous voltage or other risk. Refer servicing to qualified service personnel. Never open the
device yourself.
• Do not touch the equipment and its connected cables during an electrical storm; there may be a
risk of electric shock from lightning.
• Do not use the Alarm System to report a gas leak if the system is near a leak.
REGULAR MAINTENANCE AND TROUBLESHOOTING
Keep your Alarm Controller in optimal condition by following all the instructions that are included
within this manual and/or marked on the product.
• Clean the units by wiping with a damp cloth only.
• Do not use abrasives, thinners, solvents or aerosol cleaners (spray polish) that may enter through
holes in the Alarm Controller and cause damage.
• Do not use any water or any other liquid.
• Do not wipe the front cover with alcohol.
Occasionally, you may have a problem with your Alarm Controller or telephone line. If this happens,
your Alarm Controller will identify the problem and display an error message. Refer to the provided list
when you see an error message on the display. If additional help is required, contact your distributor
for service.
WARNING:
This equipment, Alarm System SCW9055/9057 shall be installed and used within an
environment that provides the pollution degree max 2 and over-voltages category II non-hazardous
locations, indoor only. It is designed to be installed, serviced and/or repaired by service persons only
[service person is defined as a person having the appropriate technical training and experience neces-
sary to be aware of hazards to which that person may be exposed in performing a task and of mea-
sures to minimize the risks to that person or other persons]. For EU and Australian markets, the
equipment is permanently connected; an accessible disconnect device shall be incorporated into the
building installation wiring. For North America the equipment is using a direct plug-in connection; the
socket outlet shall be installed near the SCW9055/9057 and shall be easily accessible. The plug of the
direct plug-in transformer serves as the disconnect device.
NOTE: There are no parts replaceable by the end-user within this equipment, except the batteries
for the following: the WT5500 keypad, Indoor Siren (WT4901/WT8901) and the Wireless Key
(WT4989/WT8989).
WARNING:
Never obstruct the access to the socket-outlet to which this equipment is connected.
These safety instructions should not prevent you from contacting the distributor and/or the manufac-
turer to obtain any further clarification and/or answers to your concerns.
IMPORTANT SAFETY INSTRUCTIONS
CLEANING
TROUBLESHOOTING
1