For Vigor2820V - Draytek VIGOR2820 series Quick Start Manual

1 . 1 . 3 F o r V i g o r 2 8
1 . 1 . 3 F o r V i g o r 2 8
LED
ACT (Activity)
USB
CSM
WCF
DSL
WAN2
Line
Phone 1/2
LED on Connector
Left LED
LAN 1(Giga)
(Green)
Right LED
(Green)
Left LED
LAN 2/3/4
(Green)
Right LED
(Green)
Left LED
WAN 2
(Green)
Right LED
(Green)
2 0 V
2 0 V
Status Explanation
Blinking The router is powered on and running normally.
Off The router is powered off.
On A USB device is connected and active.
Blinking The data is transmitting.
On The profile of CSM (Content Security Management) for
IM/P2P application is enabled from Firewall >>
General Setup. (Such profile is established under CSM
menu).
On The Web Content Filter is active. (It is enabled from
Firewall >> General Setup and the web content filter
profile is established under CSM menu.)
On The router is ready to access Internet through DSL link.
Blinking Slowly: The modem is ready.
Quickly: The connection is training.
On The router is ready to access Internet through WAN
connection.
Blinking It will blink while transmitting data.
On A PSTN phone call comes (in and out). However, when
the phone call is disconnected, the LED will be off
about six seconds later.
Off There is no PSTN phone call.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is connected with 10Mbps.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is connected with 10Mbps.
6
Vigor 2820 Series Quick Start Guide