Lap/Shoulder Belt Untwisting Procedure; Seat Belts In Passenger Seating Positions - Dodge Journey 2012 Owner's Manual

Hide thumbs Also See for Journey 2012:

Table of Contents

you will prefer a higher position. When you release the

anchorage try to move it up and down to make sure that

it is locked in position.

In the rear seat, move toward the center of the seat to

position the belt away from your neck.

Lap/Shoulder Belt Untwisting Procedure

Use the following procedure to untwist a twisted lap/

shoulder belt.

1. Position the latch plate as close as possible to the

anchor point.

2. At about 6 to 12 in (15 to 30 cm) above the latch plate,

grasp and twist the belt webbing 180 degrees to create a

fold that begins immediately above the latch plate.

3. Slide the latch plate upward over the folded webbing.

The folded webbing must enter the slot at the top of the

latch plate.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 53

4. Continue to slide the latch plate up until it clears the

folded webbing.

The seat belts in the passenger seating positions are

equipped an Automatic Locking Retractor (ALR) or a

cinching latch plate which are used to secure a child

restraint system. For additional information, refer to

"Installing Child Restraints Using The Vehicle Seat Belt"

under the "Child Restraints" section. The chart below

defines the type of feature for each seating position.

• N/A — Not Applicable

• ALR — Automatic Locking Retractor

Table of Contents