Glass Cleaning - Dimplex DF2600 Service Manual

Figure 4
Figure 5
4. Hold the socket while screwing in the new bulb.
UPPER LIgHT BULB REQUIREMENTS: Quantity of
2 clear chandelier or candelabra bulbs with an E-12
(small) socket base, 15 watt rating. Please refer to
the label adjacent to the upper lamps for the correct
wattage for your model.
CAUTION: Do not exceed 25 watts per lamp.
D. To reassemble lamp area
1. Replace the glass and hold it in place at the top.
2. Fasten retaining clip to hold glass in place.
HELPFUL HINTS: It is a good idea to replace all light
bulbs at one time if they are close to the end of their
rated life. Group replacement will reduce the number of
times you need to open the unit to replace light bulbs.

gLASS CLEANINg

The glass is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc., the
clear door may collect dust particles; these can be removed
by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the clear door can
be cleaned with a damp cloth. The clear door should be
completely dried with a lint free cloth to prevent water
spots.
CAUTION: Do not use abrasive cleaners on glass
surface or spray liquids directly onto any surface.
FIREPLACE SURFACE CLEANINg
Use a cloth dampened with warm water only to clean
painted surfaces of the electric fireplace. Do not use
abrasive cleaners.
Figure 6
5