Advertisement
Fireplace Installation
!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
W ARNINg: Ensure the power
cord is not installed so that
it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
W ARNINg:Construction and
electrical outlet wiring must
comply with local building
codes and other applicable
regulations to reduce the risk
of fire, electric shock and injury
to persons.
W ARNINg:Do not attempt
to wire your own new outlets
or circuits. To reduce
the risk of fire, electric shock
or injury to persons, always
use a licensed electrician.
1.
Make sure the unit's Main
ON/OFF Switch is switched
oFF (refer to operating
instruction section).
2.
Plug the unit into a 15
Amp/120 VAC outlet. If the
cord does not reach, you may
use an extension cord rated
for a minimum of 1875 Watts.
7
Hide quick links:
Advertisement
