Vivotek IP8130 User Manual page 49

You can click Restore to recall the original settings without incorporating the changes� When
completed with the settings on this page, click Save to enable the settings�
If you want to configure another sensor setting for the schedule mode, please click Profile to open
the Profile of exposure settings page as shown below.
Activated period: Select the period of time this profile setting will apply to. Please manually enter
a range of time in a day, fune the Measurement window and Exposure control settings, and then
cliack Save for the configuration to take effect.
Please follow the steps below to setup a profile:
1� Select Enable and apply this profile to�
2� Select Day mode, night mode, or Schedule time
by entering a range of time for this profile to
apply to�
3� Select the Measurement window setting�
4� Configure Exposure control settings in the
folowing columns� Please refer to previous
dicussions for detailed information�
5� Click Save to enable the setting and click Close
to exit the page�
VIVOTEK
User's Manual - 49