Viking AES--2000 Technical Practice
Accessible entry system
Hide thumbs
Also See for AES--2000:
- Technical practice (6 pages) ,
- Buyer's manual (16 pages) ,
- Application note (2 pages)
Table of Contents
Advertisement
Quick Links
TECHNICAL
TECHNICAL
AES-2000S Surface Mount
nication has been established, the tenant can activate a remote door
strike by entering a Touch Tone command. A second relay is also pro-
vided to operate an automatic door. The AES-2000 will also support
keyless entry at the door via its built-in keypad, or by adding Wiegand-
type proximity card readers, such as the Viking PROX-1.
The unit is available in flush (AES-2000F) and surface mount (AES-
2000S) configurations and features a highly vandal resistant housing.
• 16 position, back-lit display with 1/2" tall characters
• Non-volatile digital voice announcer
• Factory configured to voice announce the names for 75
apartments (expandable to 525 apartments using
ERAM-4M expansion kits, see DOD# 854)
• Non-volatile data memory for names, phone numbers
and access codes
• Volume control
• AES-NET card reader interface included
• TTY jack for connection to personal teletypewriter (TTY)
• Postal lock switch input
• Available in surface mount (AES-2000S) or flush mount
(AES-2000F) configurations
• Keyless entry capability
• 5 Amp door strike/magnetic lock control relays
• Vandal resistant features:
- 12 gauge stainless steel front panel
- 1/4" thick abrasion resistant polycarbonate display lens
- Metal keypad and push button switches
- Front panel lock
- Speaker protection screen
• Weather resistant features:
- Enamel coated circuit board
- Gasketing behind lens, speaker, keypad and perimeter
of front panel
- Sealed switches and keypad
The AES-2000 Accessible Entry System provides both audio and visu-
al assistance for those with disabilities.
The LCD display with large 1/2" tall characters is back-lit and will display
a directory of tenants as well as directions and prompts. A built in voice
recorder and announcer can also provide a supporting audio message.
When the EZ™ Access button is pressed, instructions on how to use the
system are both displayed and announced.
The built in directory can support up to 525 tenant names and phone
numbers and will dial a pre-programmed phone number upon selection
of a tenant. Once two-way commu-
• High rise apartment buildings
• Condos
• Senior citizen buildings
• Assisted care centers
• Retirement homes
• Gated communities
Power: 120V AC/13.8V AC 1.25A, UL listed adapter provided
Dimensions: AES-2000S (Surface): 311.4mm x 245.36mm x
107.9mm (12.26" x 9.66" x 4.25"), AES-2000F (Flush): 383.5mm
x 320mm x 82.55mm (15.1" x 12.6" x 3.25")
Shipping Weight: 7.7kg (17 lbs)
Environmental: -26° C to 54° C (-15° F to 130° F) with 5% to
95% non-condensing humidity (see Installation for details)
Display: 16 position, 0.5" x 4.25" back-lit LCD
Relay Contacts: 5A @ 30V DC/250V AC maximum
Connections: (20) cage clamp screw terminals
Maximum Wiegand Length (24 AWG wire): PROX-1: 244m
(800 ft), PROX-2: 122m (400 ft), HID-2: 244m (800 ft)
AES-2000
AES-2000
November 28, 2012
AES-2000F
Flush Mount
Advertisement
Table of Contents
Related Manuals for Viking AES--2000
Summary of Contents for Viking AES--2000
- Page 1 The AES-2000 will also support keyless entry at the door via its built-in keypad, or by adding Wiegand- type proximity card readers, such as the Viking PROX-1. The unit is available in flush (AES-2000F) and surface mount (AES- 2000S) configurations and features a highly vandal resistant housing.
-
Page 2: Returning Product For Repair
The following procedure is for equipment that needs repair: 1. Customer must contact Viking's Technical Support Department at 715-386-8666 to obtain a Return Authorization (RA) number. The customer MUST have a complete description of the problem, with all pertinent information regarding the defect, such as options set, conditions, symptoms, methods to duplicate problem, frequency of failure, etc. - Page 3 A. Flush Mount Chassis (AES-2000F) The AES-2000F comes with a zinc-plated steel rough-in box and a black powder-painted steel mounting ring. The rough-in box is meant to be framed into the wall. Make sure the outer edge of the box is within 1/4 inch of the finished surface of the wall, but not protruding past the surface level.
- Page 4 B. Surface Mount Chassis (AES-2000S) The AES-2000S comes with a black powder painted steel surface mount chassis. A knockout is provided on the bot- tom of the chassis as an alternate wire entrance. The four outer holes on the back of the chassis are for mounting the box to the wall.
-
Page 5: Wiring Connections
PB-100 with special software. This allows either remote programming from a distant location, or local programming using the Viking DLE-300 line simulator. The PB-100 is connected to a serial port of a P.C. and Windows based software is used to enter tenant names, phone numbers and the recording for the voice directory. -
Page 6: Apartment Selection
That code can be used as a keyless code even though keyless codes have been disabled. If the apartment phone line is wired through a Viking C-3000, the phone number field must start with a “C”. The list can be sorted according to name, apart- ment number, phone number, or code numbers by selecting the "Sort"... - Page 7 2. Download Names Screen The Download Names screen (left) is used to retrieve the tenant names, phone numbers, access codes and keyless entry codes that have been previously pro- grammed into the AES-2000. The “Present ID” box con- tains the ID number of the first record to be downloaded. The tenant ID is an unchangeable consecutive number assigned to the tenant when they were added to the database.
-
Page 8: Specifications
The Wiegand device used may be the Viking model PROX-1 Proximity Card Reader or any other card reader, RF transmitter, or digital keypad that outputs 26 bit Wiegand data. -
Page 9: Operation
AES-2000 using the PB-100 with special software. This allows either remote programming from a distant location, or local programming using the Viking DLE-300 line simulator. The PB- 100 is connected to a serial port of a P.C. and Windows based soft-... -
Page 10: Calling A Tenant
C-3000’s, see Application Note DOD# 868. Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.