Vertu Ascent RHV-3 Reference Manual page 69

Some cigarette lighter sockets are only powered
when the vehicle ignition is switched on.
The vibrating alert is disabled while the charger is
connected to your Vertu phone.
When the battery is fully charged, the battery
charge indicator stops animating. Disconnect the
car charger from the cigarette lighter outlet before
you unplug it from your Vertu phone.
C O N N E C T I V I T Y
When used in conjunction with a compatible
computer, the data cable or Bluetooth technology
allow you to use the Vertu PC Suite software,
supplied on the CD-ROM, to manage your phone
and its data. They also enable you to use your
phone as a modem to connect to the Internet or a
private network.
You will need to install Vertu PC Suite in order to
use your Vertu phone as a modem. For more
information on installing Vertu PC Suite refer to
"Installing Vertu PC Suite" on page 8-62.
DATA C ABLE
The data cable is not supplied with your
Vertu phone. It is available for purchase
from all Vertu Stores.
Connect the charger to
>
the powered cigarette
lighter outlet.
The green indicator light
>
will illuminate to show
the charger is
connected to the power
outlet. A confirmation
message is displayed if
your Vertu phone is
switched on.
Connecting the Data Cable
The headset will not operate if the headset
connector is plugged into the back of the
data cable connector.
BLUETOOTH
Your Vertu phone supports Bluetooth technology
which allows you to interact wirelessly with other
Bluetooth devices within a range of approximately
10m (30ft), although obstacles and objects
between the devices can reduce this connection
significantly.
There may be restrictions on using Bluetooth
devices in some locations. For more information
check with your local authorities.
To establish a connection between your Vertu
phone and a Bluetooth accessory, you will need to
"pair" the devices so that they can communicate.
Your phone can be paired with many different
devices and will save the settings for each but only
one Bluetooth device can be connected at any one
time.
Connect the end of
>
the data cable with
the screws attached
to the Serial (COM)
port of your
compatible computer,
ensuring it is seated
properly.
Tighten the screws.
>
Ensure your
>
Vertu phone is
switched on.
Insert the data cable
>
connector into the
bottom of your Vertu
phone as shown.
(Your data cable
connector may be
slightly different to the
one shown.)
If necessary, with the
data cable inserted, you
can also connect the
charger to your Vertu
phone.
Plug the charger
>
connector into the
back of the data cable
connector as shown.
60