Toshiba BDX2250KC Owner's Manual page 27

Customizing the Function Settings
The symbols that might appear next to each listed wireless
network in the network list are as follows:
Category Icon Defi nition
Connected When the Blu-ray Disc™
player is turned on, it will
connect to the wireless
network displaying this symbol.
Typically, this is the last
wireless network connected
before powering down.
Indicates that the Blu-ray
* Disc™ player is currently
connected to this network.
Saved The wireless network
properties have been saved
in the Blu-ray Disc™ player's
memory.
Wireless The wireless network data is
Security not encrypted.
The wireless network data
is encrypted; a 'security key'
must be entered so that the
Blu-ray Disc™ player can
share data over the network.
The wireless network data
is encrypted; the encryption
scheme is not supported by
the Blu-ray Disc™ player.
Wireless
The wireless network
a
Protocol supports 802.11a
The wireless network
b
supports 802.11b
The wireless network
g
supports 802.11g
The wireless network
n
supports 802.11n
The wireless router supports
the WPS standard.
Signal
Strong Signal
Strength
Good Signal
Medium Signal
Weak Signal
No Signal
I. Connection to the wireless Network which you
select
Wireless
Network List
WiFi Protected Setup (WPS)
Manual
IP Settings
1. In the "Wireless" menu, press /
List, then press OK. A list of existing wireless networks
near the Blu-ray Disc™ player will appear (It may
take several seconds for this list to be created). For
example:
Network List
a
WiFi
WiFi b g n
WiFi a
WiFi b g
WiFi b g
2. Press / to select the desired wireless network, and
press OK to confi rm.
a. If the Blu-ray Disc™ player is connected to an
Unencrypted Wireless Network, a menu similar to
the following will appear:
WiFi-me
Connect WPS Pin
Name and Password are case-sensitive
3. Press / to highlight Connect, and press OK. If the
wireless network is functioning,
"Connection to XXX...Success" will appear on the TV.
4. Press OK to close the message. The Blu-ray Disc™
player is now connected to the network. From now on,
when you turn on the player, it will automatically connect
to the network; there is no need to repeat these steps
again.
Note: If you do not see this message, the Blu-ray Disc™
player was not able to connect to the network.
to select Network
EN
WiFi-me*
Panda
dlink_media
NTGR 11g
Airport_SN
Cancel
icon and a message
27