Mounting Your Navigation Device - TomTom Urban Rider Owner's Manual

2. Using your TomTom Rider
Switching on
Using
your
TomTo
m Rider
Press and hold the On/Off button for 2 seconds, or until your TomTom Rider starts.
The first time you switch on your TomTom Rider, it may take up to 20 seconds to start. To
switch off your TomTom Rider, press and hold the On/Off button for 2 seconds.
Before you use your Rider for the first time, it's a good idea to charge it fully.
The battery in your TomTom Rider navigation device charges when you connect it to the
home charger or to your computer.
Note: You should plug the USB connector directly into a USB port on your computer and
not into a USB hub or USB port on a keyboard or monitor.
Setting up
First, you have to answer a few questions to set up your device. Answer the questions by
tapping the screen. You will use the touchscreen for everything you do with your TomTom
Rider.
Locating your current position
Your TomTom Rider must be outside to be able to locate your current position. Make sure
that you are in an open place without tall buildings or trees around you.
The first time you start your Rider, it can take a few minutes for the device to find your
current position. In the future, your position will be found much faster, normally within a
few seconds.
Your Rider does not transmit your location, so others cannot use it to track you while you
are driving.
TomTom Rider uses a GPS receiver to locate your current position.

Mounting your navigation device

Attach the RAM™ mount kit to your motorcycle as shown on the Installation Poster, then
place your Rider in the holder. When you are attaching the mount kit to your motorcycle,
follow these guidelines:
• If you are unsure about attaching the mount kit yourself, ask a professional to fit it for
you.
• If you choose to attach the mount kit yourself, note that the Active Dock has a built-in
fuse. This means that you don't need to add a fuse yourself while performing the con-
nection between the device and the motorcycle battery.
• Make sure that the mount kit does not interfere with any of the controls on the motor-
cycle.
3