Restoring Factory Default Settings - Teac Esoteric K-07 Owner's Manual

USB connections with a computer
Computer does not recognize this unit.
e This unit can be connected with computers running the follow-
ing operating systems.
Windows XP 32-bit
Windows Vista 32/64-bit
Windows 7 32/64-bit
Mac OS X 10.6.4 or later (32/64-bit)
Operation with other operating systems cannot be guaranteed.
Noise occurs.
e Starting other applications during playback of a music file may
interrupt playback or cause noise. Do not start other applications
during playback.
e When the unit is connected to a computer via a USB hub, for
example, noise might be heard. If this occurs, connect the unit
directly to the computer.
Audio files cannot be played back.
e Connect the computer with this unit and switch to "USB in" before
starting the music playback software and music file playback. If
you connect this unit and the computer after music playback
software has already been started, the audio data might not be
played back correctly after switching this unit's inputs to "USB in".
e To use HIGH SPEED mode, you must install a dedicated driver (see
pp.22-23).
Since this unit uses a microcontroller, external noise and other
interference can cause the unit to malfunction. If this occurs,
turn the power off once, and then restart it after waiting for
about one minute.
Beware of condensation
When the unit is moved from a cold to a warm place, or used after
a sudden temperature change, there is a danger of condensation
on the lens of CD/SACD player. Vapor in the air could cause con-
densation on the internal mechanism, making proper operation
impossible. If this occurs, or as a preventative measure, leave the
unit turned on for one or two hours. This will allow the unit to
adjust to the temperature of its surroundings.

Restoring factory default settings

POWER
Setting changes are retained even when the power cord is
disconnected.
Follow these procedures to make the unit forget setting changes and
restore all settings to their factory defaults.
1
Turn the power off.
If the unit is on, press the POWER button to turn it off and wait for
more than 30 seconds.
2
Press the POWER button while holding down
the STOP button on the main unit.
Release the STOP button when "Setup CLR" appears on the
display.
STOP
31