Input Selection And Assignment; Setting Input Levels; Recording; Undoing An Operation - Tascam DP-32 Digital Portastudio Owner's Manual

Input selection and assignment

Use the procedures described earlier in this chapter to
assign input sources to the recording tracks.

Setting input levels

After making the settings, press the PLAY (7) button to
start playback.
Just as though you were recording, you can monitor the
sound of the already recorded tracks being played back
and the input sources on the tracks for recording, allowing
you to check the monitoring balance and volume.

Recording

Press the RECORD (0) button to start recording to
another track while monitoring the playback signal.

Undoing an operation

This unit allows you to undo an operation or recording
that was not successful or satisfactory. Many ordinary
operations, including editing and recording, can be
canceled (undone).
This unit has two types of undo functions. Single undo
can be performed by a simple button press, while multiple
undo allows you to return to a specific past operation and
undo the operations that occurred after it.
You can use the undo functions for the following types of
operations.
• Track editing (functions described in this chapter)
• Recording (including track bouncing)
• Automatic punching in/out
• Track type setting
All these operations are stored on the SD card as song
information. Even when you turn the unit off (put it in
standby), the previous operations are stored and can be
undone when you turn the unit on again.
When listening to a part that you replaced in your last
recording, for example, you might find that the previous
take was better. In such a case, you can use the undo
function to easily get your previous take back.
NOTE
• The UNDO/REDO button lights when a single undo or
multiple undo has been performed.
• When you change the track type, the assignment is turned
OFF and any recorded track is deleted. If you undo this, the
recorded track will be restored and the track type changed
back, but the assignment setting will not be restored. (See
"Setting the track type" on page 40.)
6 - Basic Recording

Undo feature settings

1. When the recorder is stopped, press the MENU
button to open the
MENU
2. Use the JOG/DATA dial or the CURSOR (5/b/g/t)
buttons to select (highlight green)
and then press the F4 (t) button.
The menu screen opens.
PREFERENCE
3. Use the CURSOR (5/b) buttons to select (highlight
blue)
Undo History
4. Set the undo level.
LEVEL 1 (Default)
The is not displayed when you press
HISTORY LIST
the UNDO/REDO button. In other words, this returns
the unit to the state before the last operation (single
undo). (To cancel an undo, press the UNDO/REDO
button again.)
LEVEL 10
When you press the UNDO/REDO button, the
appears and you can return to the
HISTORY LIST
state to 10 operations earlier.
NOTE
Even when you change from
history for a maximum of 10 actions remains stored. The
position of the cursor in the HISTORY LIST shows the current
undo position.
Undoing the last operation (single
undo)
Press the UNDO/REDO button to return to the state
before the last operation.
After doing this, the UNDO/REDO button lights, showing
that redo (see below) is possible.
ª Canceling an undo operation (redo)
Press the UNDO/REDO button when it is lit.
The undone operation is redone, restoring the state
before the undo, and the UNDO/REDO button becomes
unlit.
screen.
PREFERENCE
.
to , the
LEVEL 10 LEVEL 1
47
TASCAM DP-32
,