Listening To The Demo Song - Tascam DP-32 Digital Portastudio Owner's Manual

2 - Quick Guide
CAUTION
• Do not remove or insert an SD card when the power
is ON. Always turn the power off (put in standby)
before removing or inserting an SD card.
• When the power is ON, do not disconnect the power
cord or otherwise interrupt the power to the unit.
Doing so will cause all settings made since the last
time you saved to be lost. If the power is interrupted
while an SD card is being accessed, all recorded songs
and data on the card could be damaged beyond
recovery.
• Before turning the power ON, minimize the
headphones volume and the volume on any
monitoring system connected to this unit.
TIP
By connecting an amplifier or powered speakers to the
MONITOR OUT jacks, you can monitor using speakers.

Listening to the demo song

The included SD card in the unit contains a demo song.
We will use this demo song to practice listening to and
mixing a recording.
1. Press the HOME button to open the Home screen.
2. When the recorder is stopped, press the MENU
button to open the
MENU
3. Use the JOG/DATA dial or the CURSOR (5/b/g/t)
buttons to select (highlight green)
press the F4 (t) button.
The screen opens.
SONG LIST
4. Use the JOG/DATA dial or the CURSOR (5/b)
buttons to select
DEMO SONG
F4 (t) button to open a menu list.
12
TASCAM DP-32
screen.
, and then
SONG
, and then press the
5. Use the JOG/DATA dial or the CURSOR (5/b)
buttons to select
LOAD
button.
The pop-up window appears.
SONG LOAD
6. Press the F2 ( ) button to load the demo song.
YES
The demo song is loaded and the window closes, but
the screen remains open.
SONG LIST
7. Press the HOME button to return to the Home
screen.
8. Press the PLAY (7) button, and raise the levels of
the track and STEREO faders and the MONITOR
LEVEL knob to listen to the demo song.
The STEREO fader adjusts the overall volume of the
mixer output. When the STEREO fader is at 0dB the
overall level is neither increased nor decreased.
Use the track faders to adjust the balance of the tracks.
Use the MONITOR LEVEL knob to adjust the final
monitoring volume.
9. Press the MIXER button to open the
10. Press a SOURCE buttons to select an input (A-H) or
press a SELECT button to select a track to be set.
Then use the PAN knob to set the stereo position
of that input or track. Repeat for other inputs and
tracks.
, and then press the F4 (t)
screen.
Mixer