Setting The Auto Return Start/End Point - Fostex D-160 Owner's Manual

4-1. Setting the Auto Return Start/End point

There are two ways to set the Auto Return Start point and End point: one is to hold
and store a desired time value in real-time during playback or while the D-160 is
stopped; the other is to edit and store the desired time.
Storing the Start/End point in real-time
1/9 2/10 3/11
PUNCH
IN / OUT
1. While the D-160 is playing back or stopped, press the HOLD/> key at the location
you wish to store as the Start point.
The time value obtained when you press the HOLD/> key will be held, and the
D-160 will enter the edit mode.
* The Bar/Beat Resolution menu setting is available when BAR/BEAT/CLK is used
for the Time Base. Refer to page "160" for details.
2. Press the STORE key. (The STORE LED will light up.)
3. Press the AUTO RTN START key.
The time value you held will be stored as the Start point, and the display will go
back to the previous screen that was before the time value was held. The STORE
LED will go off.
4. Press the HOLD/> key again at the location you wish to store as the End point.
5. Press the STORE key. (The STORE LED will light up.)
6. Press the AUTO RTN END key.
The time value you held will be stored as the End point, and the display will go
back to the previous screen before the time value was held.
* In steps 1 and 4 described above, you can press the STORE key instead of the
HOLD/> key, and then press the AUTO RTN START/AUTO RTN END key to set
the data more quickly.
D-160
DIGITAL MULTITRACK RECORDER
RECORD TRACK
4/12 5/13 6/14 7/15 8/16 SHIFT
LOCKED HD ACCESS MTC IN
71
D-160 Owner's Manual (Locate function)
3
6
AUTO RTN
CLIPBOARD AUTO PUNCH
AUTO PLAY IN OUT START IN OUT END
AUTO RTN
COPY MOVE PASTE ERASE UNDO REDO
AUTO
REHEARSAL
PUNCH LOCATE VARI PITCH
TAKE
RECORD STOP PLAY REWIND F FWD
CLIPBOARD PLAY
LOCATE ABS 0
LOCATE ABS END
1, 4
EXECUTE EXIT
DISP SEL /YES /NO
TIME BASE SEL
HOLD/ STORE RECALL
2, 5
PGM CHANGE