Transport/Storage - Talon EG500 Owner's Manual

Talon Manual_EG500+EG600W_v3.qxp
MAINTENANCE
Spark Plug Service
To ensure proper engine operation, the spark plug must be properly gapped and free of deposits.
If engine has been running, the spark plug will be very hot. Be careful not to touch the spark plug.
1. Remove the spark plug cap.
2. Clean any dirt from around the spark plug base.
3. Use the wrench supplied in the tool kit to remove the spark plug. (Fig. 9A)
4. Visually inspect the spark plug. Discard it if the insulator is cracked or chipped. Clean the spark plug
with a wire brush if it is to be reused.
5. Measure the plug cap with a feeler gauge. Correct as necessary by carefully bending the side electrode.
The gap should be : 0.70-0.80 mm (0.028-0.031"). (Fig. 9B)
6. Check that the spark plug washer is in good condition, and thread the spark plug in by hand to
prevent cross-threading.
7. After the spark plug is seated, tighten with a spark plug wrench to compress the washer. If installing
a new spark plug, tighten ½ turn after the spark plug seats to compress the washer. If re-installing a
used spark plug, tighten 1/8-1/4 turn after the spark plug seats to compress the washer.
NOTE: The spark plug must be securely tightened. An improperly tightened spark plug can become very
hot and could damage the engine.
Never use spark plugs which have an improper heat range. Use only the recommended spark plugs or
equivalent.
Figure 9A
AC Thermal Overload Service
If AC thermal overload requires replacement, it must be replaced with an overload switch having identical
ratings and performance characteristics. Contact your nearest Talon Authorised Servicing dealer for
replacement service.
23/05/2006 4:26 PM Page 17
Figure 9B
17
TRANSPORT/ STORAGE

TRANSPORT/STORAGE

When transporting the generator, turn the ON/OFF switch and the fuel control OFF. Keep the generator
level to prevent fuel spillage. Fuel vapour or spilled fuel may ignite.
CAUTION
Empty fuel tank before transport to avoid the risk of fuel spillage.
WARNING
Contact with a hot engine or exhaust system can cause serious burns or fires. Let the
engine cool before transporting or storing the generator.
Take care not to drop or strike the generator when transporting. Do not place heavy objects on the generator.
Before storing the unit for an extended period:
1. Be sure the storage area is free of excessive humidity and dust.
2. Service according to the table below:
STORAGE TIME RECOMMENDED SERVICE PROCEDURE TO PREVENT
HARD STARTING
Less than 1 month No preparation required.
1 to 2 months Fill with fresh gasoline and add gasoline conditioner*. / Drain the
carburetor float bowl. / Drain the fuel sediment cup.
1 year or more Fill with fresh gasoline and add gasoline conditioner*. / Drain the carburetor
float bowl. / Drain the fuel sediment cup. / Remove the spark plug. Put a
tablespoon of engine oil into the cylinder. Turn the engine slowly with the pull
rope to distribute the oil. Re-install the spark plug. / Change the engine oil. /
After removal from storage, drain the stored gasoline into a suitable container,
and fill with fresh gasoline before starting.
18