Cmos Clear; Watch Dog - Supero X7DAE User Manual

CMOS Clear

JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent the accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Always remove the AC power cord from the system before clearing CMOS. Note:
For an ATX power supply, you must completely shut down the system, remove the
AC power cord and then short JBT1 to clear CMOS.
Watch Dog Enable/Disable
Watch Dog is a system monitor that can reboot
the system when a software application hangs.
Close Pins 1-2 to reset the system if an applica-
tion hangs. Close Pins 2-3 to generate a non-
maskable interrupt signal for the application that
hangs. See the table on the right for jumper set-
tings. Watch Dog must also be enabled in the
BIOS.
LAN1/2
CD2 CD1
Line-In/
Line-
JPAC
Out
Mic
SIM LP IPMI
PCI-Exp x16
PCI-33MHz
B
CPU
PSF
J17
Fan 1
J3P
JAR
A
SCSI CTRL
320 SCSI Channel B
2-25
Chapter 2: Installation

Watch Dog

Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
(*default)
Pins 2-3 NMI
Open Disabled
8-pin PWR
A. Clear CMOS
B. Watch Dog Enable